Patton-electronic 1012B Manuale Utente

USERMANUALMODEL 1012BAsynchronousCarrier Controlled ShortRange ModemSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.patton.comPart

AT&T standard modular pin assignments4.2 WIRING FOR MULTI-POINT CIRCUITSThe Model 1012B supports multi-point applications using either astar or a

AT&T standard modular pin assignments4.2 WIRING FOR MULTI-POINT CIRCUITSThe Model 1012B supports multi-point applications using either astar or a

APPENDIX ASPECIFICATIONSTransmission Format: Asynchronous, full duplex, half duplexTransmission Line: Two unconditioned twisted pair AWG 19–26 Inter

APPENDIX ASPECIFICATIONSTransmission Format: Asynchronous, full duplex, half duplexTransmission Line: Two unconditioned twisted pair AWG 19–26 Inter

APPENDIX CMODEL 1012B BLOCK DIAGRAM13 14Notes_________________________________________________________________________________________________________

APPENDIX CMODEL 1012B BLOCK DIAGRAM13 14Notes_________________________________________________________________________________________________________

USERMANUALMODEL 503SSerial Surge ProtectorSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.patton.comPart# 07M503S-DDoc# 074201UD,R

1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1012B components to be freefrom defects, and will—at our option—repair or replace the p

1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1012B components to be freefrom defects, and will—at our option—repair or replace the p

Figure 1. Model 1012B Board, showing switch and strap locations3To change the DTE/DCE setting, do the following:1. Using a small screwdriver, insert t

Figure 1. Model 1012B Board, showing switch and strap locations3To change the DTE/DCE setting, do the following:1. Using a small screwdriver, insert t

3.2 SETTING THE RTS/CD CARRIER CONTROL JUMPERThe RTS/CD jumper (see Figure 1) is identified as J2 inside the1012B (see Figure 1). To access this strap

3.2 SETTING THE RTS/CD CARRIER CONTROL JUMPERThe RTS/CD jumper (see Figure 1) is identified as J2 inside the1012B (see Figure 1). To access this strap

Signal/Pin AssignmentsThe 6-wire RJ-11 and 8-wire RJ-45 jack options for the Model1012B are prewired for a standard TELCO wiring environment. Use theg

Signal/Pin AssignmentsThe 6-wire RJ-11 and 8-wire RJ-45 jack options for the Model1012B are prewired for a standard TELCO wiring environment. Use theg